TM 9-2320-280-34
This task covers:
a. Removal
c. Installation
b. Repair
INITIAL SETUP:
T___s
_ ool _
E___i____n___on__tion
_ qu pme_t C __di _
General mechanic's tool kit:
Oil pan removed (TM 9-2320-280-20).
Maint_____ce ___ el
_____ enan __Lev
Direct support
____ual R____ nce
Man_____efere___ s
TM 9-2815-237-34
TM 9-2815-237-34P
TM 9-2320-280-20
a. Removal
1.
Remove nut (6) from pickup tube bracket (4) and stud (7).
2.
Loosen capscrew (3) from bracket (4) and oil pickup tube (5) and slide bracket (4) off stud (7).
3.
Remove stud (7) from oil pump (8) and rear main bearing cap (2).
4.
Remove oil pump (8) and shaft (9) from cylinder block (1).
5.
Remove capscrew (3) and bracket (4) from oil pickup tube (5).
b. Repair
For repair procedures for oil pump, refer to TM 9-2815-237-34.
c. Installation
1.
Install bracket (4) on oil pickup tube (5) with capscrew (3). Finger tighten capscrew (3).
2.
Install oil pump (8) and shaft (9) on rear main bearing cap (2).
3.
Install stud (7) on oil pump (8) and rear main bearing cap (2) and tighten to 59-74 lb-ft (80-100
Nm).
Secure bracket (4) on stud (7) with nut (6). Tighten nut (6) to 35 lb-ft (47 Nm).
4.
5.
Tighten capscrew (3) to 12 lb-ft (16 Nm).