TM 9-2320-289-34
10-8.
WINDSHIELD WIPER MOTOR REPAIR (Con’t).
6 .
Push in retainer tab and remove washer solenoid and park switch assembly (1 3).
7 .
Remove retainer ring (15) and pawl (16) from shaft (17).
8.
Remove screw (21) and dog spring (20) from washer frame.
9 .
Move leg of retainer spring (19) out of shaft (12) groove. Remove ratchet
shaft.
gear (18) from
10.
Pull piston housing (25) away from washer frame (26) until mounting grooves clear frame.
Remove valve assembly (24), piston housing, and piston actuator plate (27) as a unit.
11.
Remove 4 screws (22) and cover (23) from valve assembly (24). Remove gasket from
between cover and valve assembly. Remove pump seal. Discard gasket and pump seal.
b.
ASSEMBLY
NOTE
l If assembling washer pump assembly, perform steps 1-5.
l If assembling crank arm assembly, perform step 6.
l If assembling armature and end cap assembly, perform steps 7-11.
1.
Install new pump seal in piston housing (25) grooves.
Install new gasket between valve
assembly (24) and cover (23). Aline valve and cover assembly with piston housing and start 4
screws (22). Tighten 4 screws to evenly draw in cover.
TA50408
10-28
