10-8. WINDSHIELD WIPER MOTOR REPAIR (Cont)

10-8. WINDSHIELD WIPER MOTOR REPAIR (Cont) - TM-9-2320-289-34_813

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
797

TM 9-2320-289-34 10-8. WINDSHIELD WIPER MOTOR REPAIR (Con’t). 9 . Install armature (2) in end cap assembly (7). Rotate brush springs (28) counterclockwise to reposition them in retainer notches (30). Using wire (32), secure armature to end cap assembly. NOTE Strong magnetic field will pull armature (2) toward one of the magnets. It will be necessary to overcome this force to start shaft into bearing. Before end cap assembly (7) enters housing (l), wire (32) must be removed. l l 10. Guide armature worm gear (33) through housing (1) bearing. Terminal housing of end cap assembly (7) goes into slot area of housing, Rotate crank arm (8) slightly to engage armature worm gear shaft with gear teeth, Push on end cap assembly until it bottoms against end of housing. TA50411 10-31

Privacy Statement
Press Release
Contact