TM 9-2320-289-34
3-3. ENGINE AND ENGINE MOUNT REMOVAL (Con’t).
5.
Remove locknut (20) and screw (16) from left side engine mount (21 ) and engine mount
bracket (1 7), Repeat for right side. Discard locknuts. Disconnect positive starter cable from
clip on oil p-an.
l
l
l
CAUTION
When raising or supporting engine for any reason, DO NOT use jack
under engine oil pan, crankshaft puley, or any sheet metal. Use
suitable lifting device installed at lifting eyes. Failure to follow this
caution may result in damage to engine oil pan, crankshaft pulley, or
sheet metal.
If only removing engine mount (21) or engine mount brackets (17), and
no other engine components have been removed, engine should only
be raised until there is enough clearance to remove bolts (22). Raising
engine too far may result in damage to engine components.
If removing engine mounts (21) or engine mount brackets (17)) lifting
device should be installed to right or left front of engine.
6.
Install a suitable lifting device on engine lift brackets at left front and right rear of engine.
Position wiring harness over transmission oil filler tube. Position vacuum modulator lines to
right of lifting device.
7.
Raise side of engine (19) where engine mount (21) is to be removed.
8.
Remove 3 bolts (22), washers (23), engine mount bracket (17), and spacer (18) if damaged.
Remove 3 locknuts, bolts, washers, and engine mount (21). Leave lift in place and repeat step
for other side. Discard. locknuts and engine mount if damaged.
TA50618
3 - 5
