TM 9-2320-289-345-12.TRANSMISSION AND TORQUE CONVERTER MAINTENANCE (Con’t).4.Inspect torque converter for damaged weldnuts or bolt hole threads. Inspect torque converterhub for scoring. If weldnuts or bolt hole threads are damaged or hub is scored, replace torqueconverter.c.INSTALLATION WARNINGTransmission (1) and torque converter (16)provide support during installation. Failureare heavy. Use caution andto follow this warning mayresult in serious injury to personnel or equipment damage.CAUTIONEnsure that torque converter (16) is fully seated in transmission (1).Failure to follow this caution will result in damage to torque converter andtransmission,1.Place transmission (1) on transmission lift and tilt transmission slightly backwards. Installtorque converter (16) in transmission by rotating torque converter to fully engage with turbineshaft, stator shaft,2.Raise transmissionNOTETop right bolt (7)and oil pump drive gear tangs.(1) on transmission lift into position. Slide straight onto 2 locating pins (17).also securesexhaust manifold heat shield.3.Loosely install 4 bolts (7) securingtransmission (1) to engine (9), thenfully tighten bolts.4.Position wiring harness clip at upperleft bolt hole and install bolt (6).Install fill tube assembly (12) intransmission.Positionfilltubeassembly bracket at upper right bolt’hole and install bolt (6). Installtransmission fluid indicator (8).5.Remove support from engine (9).5-61
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business