5-13. INSTALLING AND REMOVING TRANSMISSION FROM HOLDING FIXTURE (Cont)

5-13. INSTALLING AND REMOVING TRANSMISSION FROM HOLDING FIXTURE

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
410

TM 9-2320-289-34 5-13. INSTALLING AND REMOVING TRANSMISSION FROM HOLDING FIXTURE (Con’t). NOTE A suitable container should be used to catch hydraulic fluid that may drain from transmission (2). 1. Install holding fixture (1) to transmission (2) so that vacuum modulator will be on side of holding fixture nearest the bench. 2. Install holding fixture (1) and transmission (2) to holding fixture base (5). 3. Install pin (4). Tighten screw (3). DO NOT over tighten screw to allow holding fixture (1) to rotate when pin is removed. TA50249 5-66

Privacy Statement
Press Release
Contact