b. INSTALLATION - TM-9-2320-289-34

4-12. CAB HEATER CONTROL, ENGINE DIAGNOSTIC, AND OPEN DOOR BUZZER WIRING HARNESSES REPLACEMENT (Cont)

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
334

TM 9-2320-289-34 4-12. CAB HEATER CONTROL, ENGINE DIAGNOSTIC, AND OPEN DOOR BUZZER WIRING HARNESSES REPLACEMENT (Con’t). b. INSTALLATION 1 . 2 . 3 . 4 . 5 . l If installing and 2. l if installing l If installing NOTE open door buzzer wiring harness (25), perform steps 1 engine diagnostic wiring harness (14), perform steps 3-5. cab heater control wiring harness, perform steps 6-10. . Ensure that all connectors are seated and locked in place as they are installed. Connect open door buzzer wiring harness (25) to instrument panel wiring harness (3). Secure open door buzzer wiring harness (25) to instrument panel wiring harness (3) with clip (23). Slide open door buzzer wiring harness onto fuse box (24). Inside engine compartment, push engine diagnostic wiring harness (14) through grommet (21 ). Connect engine diagnostic wiring harness to engine wiring harness (22). NOTE Ensure that indexing pin on front of engine diagnostic wiring harness (14) is installed in 12 o’clock position. Assemble engine diagnostic wiring harness (14) and diagnostic connector bracket (19). install cap (18), 4 screws (17), and nuts (13). Install diagnostic connector bracket (19) and wiring harness accessory bracket (15) on dash panel (16) with 2 screws (20). TA60854 4-89

Privacy Statement
Press Release
Contact