11-23. CARGO COMPARTMENT HEATER WIRING HARNESS REPLACEMENT (M1008 AND M1008A1)

11-22. CARGO COMPARTMENT HEATER FUEL LINES REPLACEMENT (M1008 AND M1008A1) (Cont)

11-23. CARGO COMPARTMENT HEATER WIRING HARNESS REPLACEMENT (M1008 AND M1008A1) (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
693

TM 9-2320-289-20 11-23. CARGO COMPARTMENT HEATER WIRING HARNESS REPLACEMENT (M1008 AND M1008A1). This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Condition Materials/Parts • Rear battery box removed. • Three Iockwashers (See paragraph 11-6) • Eleven straps a. REMOVAL NOTE • If removing wiring harness (1) from M1008, perform steps 1-4. • If removing wiring harness from M1008A1, perform steps 5-7. • Tag all leads and connectors for installation. 1. Loosen 2 nuts (6) and remove positive accessory wiring terminal board cover (5). Remove nut and lockwasher from positive accessory wiring terminal board stud, and disconnect wiring harness (1) lead. Repeat for negative accessory wiring terminal board (7). Discard Iockwashers. TA50110 11-85

Privacy Statement
Press Release
Contact