TM 9-2320-289-2010-30. INTERIOR SLIDING DOOR REPLACEMENT (M1010).This task covers:a.Removalb. InstallationINITIAL SETUP:Materials/PartsFour rivetsTwo screwsa.REMOVAL1.2.3.4.5.6.7.8.9.10.NOTEIf removing window glass, see paragraph 10-27.If removing sliding door (2), perform steps 1-5.If removing handles (8 and 16), slam lock (9), and hasp and shaftassembly (11), perform steps 6-9.If removing blackout curtain (5), perform step 10.Rivets (14) are not replaceable, use screws for installation.Remove 2 rivets (14) securing bracket (13) to side frame. Discard rivets.Remove 2 screws (12) and floor track (15) with attached bracket (13).NOTESome models may have 2 washers and Iockwashers in addition to 2 bolts(1) and nuts (4), DO NOT use washer and Iockwasher for installation.Remove left nut (4) at roller track (3). Remove left bolt (1).Close sliding door (2) and remove right nut (4) at roller track (3). Remove right bolt (1).Open sliding door (2). Remove sliding door while holding roller track (3) stationary.Remove setscrew and handle (8).Remove 4 nuts (10), bolts (7), and slam lock (9).Turn handle (16) to gain access to 2 screws (17). Remove screws, handle, and hasp and shaftassembly (11).Remove pin and remove handle (16) from hasp and shaft assembly (11).Remove 4 rivets (6), snap fastener, and blackout curtain (5). Discard rivets.10-110
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business