10-4. HOOD, HINGE, AND LATCH REPLACEMENT

10-4. HOOD, HINGE, AND LATCH REPLACEMENT (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
479

TM 9-2320-289-20 10-4. HOOD, HINGE, AND LATCH REPLACEMENT. This task covers: a. Removal c. Hood Alinement b. Installation INITIAL SETUP: Equipment Condition Personnel Required • Ventilator panel removed (if removing hinge). • MOS 63B (2) (See paragraph 10-3) NOTE if removing primary latch (2), perform steps 1 and 2. If removing hood (8), perform steps 3 and 4, If removing hinge (11) or hinge spring (14), perform steps 3 and 5 as required. 1. Open cable c l i p ( 4 ) , r e m o v e grommet (6) from primary latch (2), and remove hood latch cable (5) from primary latch. 2. Remove 2 bolts (7) and primary latch (2). Remove 2 bolts (3) and support (1) if damaged. NOTE • If removing hinge (11) or hinge spring (14), only remove 4 bolts (9) from one side. • Mark position of hinges (11) on hood for installation. • If hood seal (15) is not damaged, save for installation on new hood. 3. Remove 4 bolts (9) from each side of hood (8) . Remove hood. Inspect hood seal (15) for damage. Remove hood seal and discard if damaged. 4. Remove 2 bolts (18), secondary latch (17), and spring (16) if damaged. TA49932 10-6

Privacy Statement
Press Release
Contact