TM 9-2320-289-20
9-8. REAR BUMPER, TOW HOOK BRACKET, AND TIE-DOWN CLEVISES
REPLACEMENT (M1009) (Con’t).
4.
Remove cotter pin (5) from pin (3). Remove pin and tie-down clevis (4). Discard cotter pin.
Repeat step to remove other tie-down clevis.
5.
Remove 2 bolts (1) and washers (14) securing tow hook bracket (12) to crossmember.
Remove 2 bolts (7) and washers (6).
NOTE
Bumper (2) is factory-installed with locknuts and washers instead of nuts
(17) and Iockwashers (16). Use nuts and Iockwashers for installation.
6.
Remove 4 nuts (17), Iockwashers (16), washers (15), and bolts (24) securing bumper (2) to 2
bumper braces (18). Discard Iockwashers.
WARNING
Support bumper (2) during removal, If dropped, it may cause serious
injury to personnel.
7.
Remove 4 nuts (20), lockwashers (21), washers (22), and bolts (23) securing bumper (2) to 2
bumper braces (19), Remove bumper with tow hook bracket (12) and pintle hook (8)
attached. Discard Iockwashers.
8.
Remove pintle hook (8). (See paragraph 9-5)
TA49711
9-17
