TM 9-2320-289-209-9.REAR BUMPER SUPPORTS REPLACEMENT (M1009).This task covers:a. Removalb. InstallationINITIAL SETUP:Equipment ConditionMaterials/Parts• Rear bumper, tow hook bracket, andtie-down clevises removed.(See paragraph 9-8)Too/s/Test EquipmentT o r q u e w r e n chScrewdriver bit set, J-29843One locknutSeven IockwashersOne plastic tiea . R E M O V A L 1.2.3.4.5.6.7.8.9.NOTERear bumper supports are removed the same way on both sides. Rightside removal is shown.Remove 4 nuts (8), 8 washers (9), 4 bolts (25), and reinforcement (24).Remove plastic tie securing wiring harness to bumper brace (16). Discard plastic tie.Remove 2 nuts (3), Iockwashers (4), and bolts (15), and remove bumper brace (16). DiscardIockwashers.Remove nut (30), Iockwasher (1), and stud (7).Remove 2 nuts (27 and 29), Iockwashers (26Iockwashers.Remove nut (14), Iockwasher (13), and bolt (2)Discard Iockwasher.and 28), and bolts (18 and 19). DiscardDiscard Iockwasher.Remove nut (23), Iockwasher (22), washer (21), and bolt (5) securing tow hook reinforcementbracket (11) to frame. Discard Iockwasher.Remove locknut (17), bolt (10), and tow hook reinforcement bracket (11). Remove tie-downclevis bracket (12), tie-down extension (20), and bumper brace (6). Discard locknut.Remove tie-down extension (20) from tie-down clevis bracket (12).b.INSTALLATIONNOTERear bumper supports are installed the same way on both sides. Right sideinstallation is shown.1.9-20Install tie-down clevis bracket (12) to frame with bolt (2), new Iockwasher (13), and nut (14).DO NOT fully tighten nut.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
