b. INSPECTION - TM-9-2320-289-20

8-2. WHEEL AND TIRE MAINTENANCE (Cont) - TM-9-2320-289-20_433

8-2. WHEEL AND TIRE MAINTENANCE (Cont) - TM-9-2320-289-20_435

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
413

TM 9-2320-289-20 8-2. WHEEL AND TIRE MAINTENANCE (Con’t). 1 . Inspect tire for cuts, gouges, cracks, and sidewall damage. (See TM 9-2610-200-14) Check for protruding objects inside tire which may not be visible from outside. Repair tire as required. (See TM 9-2610-200-14) 2. Inspect valve stem (7) and valve core (6) for cracks. Replace if cracked. 3. Inspect wheel rim (4) for bends and other damage. Replace if bent or damaged. 1. Install valve core (6) in valve stem (7) and install tire on wheel rim (4), (See TM 9-2610-200-14) Inflate tire as required. (See TM 9-2320-289-10) Check for leaks in valve stem, valve core, and around edge of wheel rim. Install valve cap (5). Balance tire and wheel assembly. (See TM 9-4910-743-14&P) NOTE Perform step 1.1 for M1028A2 and M1028A3 only. Only rear dual wheel has spacer ring (3.1). When installing outer rear wheel (3), ensure that valve stems are positioned 180° apart and that inner valve stems are accessible through hole in outer rim. 1.1. Position inner rear wheel (3), spacer ring (3.1), outer rear wheel or front wheel, and clamping ring (3.2) on wheel hub. Install lugnuts (1) finger tight. Remove jack stand (2) and lower truck. 8-3.0 Change 2

Privacy Statement
Press Release
Contact