TM 9-2320-289-208-4.ROTOR AND WHEEL BEARINGS MAINTENANCE.This task cowers:a. Removalc. Installationb. Cleaning and InspectionINITIAL SETUP:Equipment ConditionMaterials/PartsCaliper removed. (See paragraph 7-11)•Front locking hub removed.•(See paragraph 8-3)••••#4-40 ScrewOne sealSix Iockwashers (all except M1009)Six locknuts (Ml 009)Dry cleaning solvent(Item 15, Appendix C)Grease (Item 26, Appendix C)Tools/Test EquipmentManual References••••••Annular bearing inserter, J-23445-A• TM 9-2320-289-20PNut wrench, J-26878-A (all except M1009)Nut wrench, J-34616 (1984, M1009 trucks)Hub nut wrench, J-6893-D(1985-87, M1009 trucks)Snapring pliersTorque wrenchGeneral/Safety Instructions• Dry cleaning solvent is flammable and must not be used near an open flame. Use only in awell-ventilated area.• DO NOT use a dry brush or compressed air to clean brake pads or brake components.NOTE• If removing rotor, wheel bearings, and caliper bracket from all exceptRA1009, perform steps 1, 4, and 5.• If removing rotor, wheel bearings, and caliper bracket from M1009,perform steps 2-4, and 6.Change 28-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
