TM 9-2320-289-207-11.BRAKE PAD AND CALIPER REPLACEMENT (Con’t).M1009NOTENote location of anti-rattle clip (12) or spring (23) for installation.7.Remove brake pads (11 and 13) or (21 and 22) from caliper housing (8 or 20). Removeanti-rattle clip (12) or spring (23). Remove 2 sleeves (16), inner bushings (17), and outerbushings (19) as required.WARNINGDO NOT use a dry brush or compressed air to clean brake pads or brakecomponents, There may be asbestos dust on brake pads or brakecomponents which can be dangerous to you if you breathe it. Brake padsand brake components must be wet, and a soft brush must be used.Failure to follow this warning may result in serious illness or death topersonnel.NOTEAlways replace brake pads (11, 13, 21, and 22) in sets, If 1 brake pad isreplaced, ensure that all brake pads are replaced.8.Clean off dirt from brake pads (11 and 13) or (21 and 22). Inspect for glazing, oil saturation, orexcessive wear. Replace brake pads if glazed or oil saturated, or if brake pad lining is worn towithin 0.031 in. (0.80 mm) of a rivet head or pad itself.TA496837-35
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
