TM 9-2320-289-20
7-11.
BRAKE PAD AND CALIPER REPLACEMENT (Con’t).
3.
Position “C“ clamp around caliper (2) so that foot of clamp on shaft rests through access hole
(3) against outer brake pad (11 or 22) and stationary foot of clamp rests on piston (14),
Tighten “C” clamp until piston reaches bottom of piston bore. Remove “C“ clamp.
NOTE
Use soft-faced hammer and drift to remove key (5) and spring (7).
Note position of spring (7) for installation.
4.
Remove screw (6), Tap key (5) and spring (7) from bracket (4). Remove caliper
bracket and rotor (1).
All Except M1009
5.
Remove 2 mounting bolts (15). Remove caliper (2) from bracket (18) and rotor (1).
CAUTlON
DO NOT allow caliper (2) to hang from brake hoses. Damage to hoses may
result.
6.
Position caliper (2) on axle and secure with supporting wire.
TA49682
7-34
