TM 9-2320-289-20
7-11.
BRAKE PAD AND CALlPER REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Equipment Condition
MaterialslParts
• Front wheel removed. (See paragraph 8-2)
• TWO copper washers
• Brake fluid (Item 6, Appendix C)
• Grease (Item 26, Appendix C)
General Safety Instructions
• DO NOT use a dry brush or compressed air to clean brake pads or brake components.
a.
REMOVAL
NOTE
If removing caliper (2) from all except M1009, perform steps 1-4 and 8.
If removing caliper (2) from M1009, perform steps 1-3, 5, and 8.
If removing brake pads from all except M1009, perform steps 3, 4, and 6
through 8.
If removing brake pads from M1009, perform steps 3 and 5 through 8.
Use a suitable container to catch brake fluid from disconnected caliper
fiex hose.
1.
Remove bolt and 2 copper washers and disconnect caliper flex hose from caliper (2). Discard
copper washers.
2.
Remove dust cap (10) and bleeder valve (9) if damaged.
7-33
