TM 9-2320-289-207-7.BRAKE SHOE AND WHEEL CYLINDER REPLACEMENT (Con’t).NOTEM1009 DOES NOT use a lock-washer (31) with anchor pin (2).12.Remove nut (30), Iockwasher (31),and anchor pin (2) as required.Discard Iockwasher.13.Remove cap (28), bleeder valve(29), and 2 link rods (35) asrequired. Remove 2 bolts (27) andwheel cylinder (34) from backingplate (1).NOTEStep 14 applies to all exceptM1009.14.Remove 4 bolts (33) and Iockwashers(32), and remove backing plate (1)from axle (36). Discard Iockwashers.b.INSTALLATION WARNING•••••DO NOT use a dry brush or compressed airbrake components. There may be asbestosbrake components which can be dangerousto clean brake shoes ordust on brake shoes orto vou if vou breathe it,Brake shoes and brake components must be wet, and a soft brush mustbe used. Failure to follow this warning may result in serious illness ordeath to personnel.Always wear goggles during installation of brake shoe springs. Failureto follow this warning may result in serious eye injury.NOTEIf installing wheel cylinder (34), perform steps 2-16.If Installing brake shoes (5 and 17) and mounting hardware, performsteps 3-16.Step 1 applies to all except M1009.1.Install backing plate (1) on axle (36) with 4 newto 105 Ib.-ft. (142 N•m).Iockwashers (32) and bolts (33). Tighten boltsTA496677-17
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
