TM 9-2320-289-20
4-40.
SLAVE RECEPTACLE REPLACEMENT.
This task covers:
a.
Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
Both battery negative cables disconnected.
Two Iockwashers
(See paragraph 4-38)
Radiator grille removed. (See paragraph 10-2)
Retainers and clips removed from cables,
as required, if replacing cables.
(See paragraph 4-38)
1.
2.
3.
4.
5.
6.
7.
8.
NOTE
If removing slave receptacle cables (6 and 20), perform steps 1 and 2.
If removing slave receptacle (17), perform steps 2 and 4-8.
Tag terminal studs and both ends of slave receptacle cables (6 and 20)
for-installation.
Remove 4 nuts (11) and bolts (19).
Remove cover
(18) from slave
receptacle (17) as required.
Remove slave receptacle (17) and 2
spacers (10).
Remove 2 screws (16), screws (9),
and “U” nuts (7).
Remove slave receptacle bracket
(8) .
Replace
grommet (15) if
damaged.
Remove 2 mounting nuts (14) if
damaged.
Loosen nuts (4) and remove accessory wiring terminal board covers (1). Remove 2 nuts and
Iockwashers from accessory wiring terminal board studs (2 and 3). Disconnect positive cable
(6) from stud (2). Disconnect negative cable (20) from stud (3). Discard Iockwashers.
Remove 2 screws (13) and washers
(12), and disconnect cables (6 and
20) .
Pull slave receptacle cables (6 and
20) through slave receptacle bracket
(8) and grommet (5). Replace
grommet if damaged.
4-84
