TM 9-2320-289-203-33.RADIATOR HOSES AND CLAMPS REPLACEMENT.This task covers:a. Removalc. Installationb. Cleaning and InspectionINITIAL SETUP:Equipment ConditionGeneral Safety InstructionsCooling system drained.Servicing of engine cooling system(See paragraph 3-30)should only be performed on a coolengine.a.REMOVALWARNINGServicing of engine cooling system should only be performed on a coolengine. Never remove clamps (2 and 5) or hoses (4 and 6) when engine ishot. Pressurized steam or hot water will cause serious burns.NOTEHose support (1) secures both radiator inlet hose (4) and front axle venthose (7) to fan shroud.1.Remove bolt (3), front axle vent hose (7), and hose support (1).2.Remove 2 clamps (2 and 5) and radiator inlet hose (4).3.Remove 2 clamps (2) and radiator outlet hose (6).b. CLEANING AND INSPECTION I1.Clean all hose connection areas.2.Inspect radiator inlet hose (4) and radiator outlet hose (6) for cracks, punctures, or splits.Replace if any of these conditions exist.3.Inspect all clamps (2 and 5) and hose support (1) for signs of damage, wear, or corrosion.Replace if any of these conditions exist.c.INSTALLATIONCAUTIONEnsure that extra large tab (hose protector) on clamp (5) is positioned atbottom when clamp is fully installed to prevent radiator hose damage fromair conditioner or alternator belt.1.Install radiator inlet hose (4) with 2 clamps (2 and 5).3-98
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
