b. CLEANING AND INSPECTION

3-32. COOLANT RECOVERY RESERVOIR REPLACEMENT.

3-33. RADIATOR HOSES AND CLAMPS REPLACEMENT.

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
209

TM 9-2320-289-20 3-32. COOLANT RECOVERY RESERVOIR REPLACEMENT (Con’t). NOTE When bolt (4) securing coolant reservoir (5) to mounting bracket (10) is removed, engine oil sampling valve bracket (3) is also removed. Save it for installation. 3. Remove bolt (4), engine oil sampling valve bracket (3), and nut (2). 4. Remove 2 bolts (9) from mounting bracket (10). 5. Remove forward lamp harness ground wire (1), starwasher, mounting bracket (10), and coolant reservoir (5). Discard starwasher. b. CLEANING AND INSPECTION 1. Empty coolant reservoir (5) and ensure that it is clean and free of contamination. If required, wash with soap and water. Rinse thoroughly. 2. Inspect coolant reservoir (5) for cracks, punctures, or splits. If any of these conditions exist, install new coolant reservoir. 3. Inspect all coolant reservoir (5) mounting hardware. Replace if bent or broken. c. INSTALLATION 1. Install bottom lip of coolant reservoir (5) into bracket (8). 2. Install mounting bracket (10), new starwasher, forward lamp harness ground wire (1), and 2 bolts (9) . 3. Install engine oil sampling valve bracket (3) with bolt (4) and nut (2) through mounting bracket (10). 4. Install coolant reservoir hose (6) with clamp (7). 5. Refill coolant reservoir (5). (See LO 9-2320-289-12) 3-97

Privacy Statement
Press Release
Contact