b. INSTALLATION - TM-9-2320-289-20

3-34. T H E R M O S T A T , W A T E R O U T L E T , A N D C R O S S O V E R P I P E H O U S I NG REPLACEMENT (Cont)

3-34. T H E R M O S T A T , W A T E R O U T L E T , A N D C R O S S O V E R P I P E H O U S I N G REPLACEMENT (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
214

TM 9-2320-289-20 3-34. T H E R M O S T A T , W A T E R O U T L E T , A N D C R O S S O V E R P I P E H O U S I NG REPLACEMENT (Con’t). 9. Remove clamp (22) and crankcase depression regulator valve hose (21) from oil filler neck (23). NOTE In order to perform step 10, it may be necessary to remove air cleaner. (See paragraph 3-9) Nut described in step 10 is located on right side of cylinder block in M1010. 10. On left side, remove nut from alternator ground wires from point where crossover pipe (6 or 15) attaches to cylinder block. 11. Remove 2 studs (16) and 2 bolts (13) from crossover pipe (6 or 15) at attachments to left and right cylinder head. Remove crossover pipe and 2 gaskets (14). Discard gaskets. b. INSTALLATION NOTE Ensure that all gaskets and mating surfaces are clean. If installing thermostat assembly (11) and water outlet (10), perform steps 11-14. 1. Install 2 new gaskets (14) and crossover pipe (6 or 15) with 2 studs (16) and bolts (13). NOTE Nut described in step 2 is located on right side of cylinder block in M1010. 2. On left side, install nut securing alternator ground wires at point where crossover pipe (6 or 15) attaches to cylinder block. 3. Install crankcase depression regulator valve hose (21) to oil filler neck (23) with clamp (22). TA49840 3-102

Privacy Statement
Press Release
Contact