TM 9-2320-280-34
This Task Covers:
a.
Right Front Insert Panel Fabrication
f.
Metal Strip C and Insert Panel Assembly
b.
Metal Strips Fabrication
g.
Right Front Floor Panel and Battery Tray Drilling
c.
Right Front Floor Panel Removal
h.
Right Front Floor Panel and Insert Panel Drilling
d.
Metal Strip A and Insert Panel Assembly
i.
Battery Tray Panel and Right Front Floor Panel Installation
e.
Metal Strip B and Insert Panel Assembly
j.
Insert Panel and Right Front Floor Panel Installation
INITIAL SETUP:
Tools
General mechanic's tool set:
Equipment Condition
automotive (Appendix G, Item 1)
Battery cover removed (TM 9-2320-280-20).
Manual References
Batteries removed (TM 9-2320-280-20).
Battery tray removed (TM 9-2320-280-20).
TM 9-2320-280-24P
Right front floor insulation removed
TM 9-2320-280-20
(TM 9-2320-280-20).
TM 43-0139
Maintenance Level
Materials/Parts
General Support
Seventy-five blind rivets
(Appendix E, Item 194)
Fifty-five blind rivets (Appendix E, Item 195)
Adhesive (Appendix B, Item 1.1)
Adhesive sealant (Appendix B, Item 4.1)
Front battery holdown bracket
(Appendix E, Item 3)
Rear battery holdown bracket
(Appendix E, Item 4)
Battery tray (Appendix E, Item 257)
Sheet metal (Appendix E, Item 245)
NOTE
All dimensions in this procedure are in inches.
a. Right Front Insert Panel Fabrication
1.
Cut insert panel (1) from sheet metal, and mark four reference lines (2) and directional arrow (3) on
insert panel (1).
2.
Fabricate two drain holes (4) in insert panel (1).
3.
Remove all burrs and round all sharp edges of insert panel (1).
Change 2
