TM 9-2320-280-34
18-3. TRANSFER CASE REPAIR (Model 218) (Cont'd)
d. Assembly
NOTE
For general assembly instructions, refer to para. 2-16.
Ensure rubber surface of seal faces yoke seal installer.
1.
Using yoke seal installer, install seals (1) and (2) in front case (3).
NOTE
Ensure input gear oil seal is installed with 0.125 in. (3.17 mm) of
seal out of front end housing as shown.
Ensure rubber surface of seal faces yoke seal installer.
2.
Using yoke seal installer, install seal (2) in front case (3).
3.
Install sector shaft O-ring (8) and retainer (9) in front case (3).
4.
Install range sector (4) and operating lever (10) in front case (3) with washer (11) and locknut (12).
Tighten locknut (12) to 28 lb-ft (38 N.m).
5.
Install poppet (5), spring (6), and retaining bolt (7) in detent bore in front case (3). Tighten
retaining bolt (7) to 22 lb-ft (30 N.m).
6.
Move operating lever (10) down to last detent.
18-16
Change 2
