TM 9-2320-280-34
18 - 3. TRANSFER CASE REPAIR (Model 218) (Cont' )
d
27.
Inspect rear case output shaft bearing (8). If damaged, perform steps 28 and 29. If not, go to step 30.
28.
Using bearing remover, slide hammer adapter, and slide hammer, remove bearing (8) and seal (7)
from rear case (6). Discard seal (7).
29.
Using driver handle and rear output shaft bearing installer, install seal (7) and bearing (8) in rear
case (6).
30.
Inspect annulus gear bushing (10). If damaged, perform steps 31 and 32. If not, go to step 33.
31.
Using driver handle and annulus gear bushing remover, remove bushing (10) from annulus gear (9)
32.
Using driver handle, annulus gear bushing remover and annulus gear bushing installer, install
bushing (10) in annulus gear (9).
33.
Inspect range fork (11), mode selector fork (13), and pads (12) for damage. Replace any if damaged.
34.
Refer to para. 2-14 for general inspection instructions for all other transfer case parts.
