TM 9-2320-280-34
17 - 3. TRANSMISSION DISASSEMBLY INTO SUBASSEMBLIES (Cont' )
d
h. Front Servo
Remove front servo pin (4), piston (2), retaining ring (3), spring retainer (5), and spring (6) from case (7).
i Rear Servo
1.
Remove six capscrews (1), servo cover (12), and gasket (11) from case (7). Discard gasket (11).
2.
Remove rear servo piston (10), accumulator piston (9), and spring (8) from case (7).
j. Oil Pump
1.
Position transmission case (7) so oil pump (15) faces up.
2.
Remove six capscrews (13), seal washers (14), and oil pump (15) fro case (7). Discard
m
seal washers (14).
3.
Install slide hammer adapters into threaded holes in oil pump (15).
4.
Using slide hammer and adapters, remove oil pump (15) and gasket (16) from case (7). Discard
gasket (16).
17-6
