TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Manual References
M966, M996A1, M1036, M1045, M1045A1,
TM 9-2320-280-24P
M1045A2, M1046, M1046A1
Maintenance Level
Materials/Parts
Direct Support
Twenty-eight blind rivets
(Appendix E, Item 192)
Adhesive sealant (Appendix B, Item 3)
NOTE
If blast shield is secured with spot welds, replace with kit
57K0223. Installation instructions are included with kit.
If it is riveted, proceed with task.
For instructions on replacement of rivets, refer to para. 22-7.
a. Removal
Remove twenty-eight rivets (1) and blast shield (2) from roof (3). Discard rivets (1).
b. Installation
NOTE
Use old blast shield as a template for drilling holes in new blast
shield before installing on vehicle.
1.
Using old blast shield as a template, locate, mark, and drill twenty-eight .194-in. (4.93 mm)
diameter holes in new blast shield.
2.
Apply adhesive sealant to blast shield (2) and install blast shield (2) on roof (3) with twenty-eight
rivets (1).
Change 2
