TM 9-2320-280-34
14-5. WINDSHIELD MAINTENANCE (Cont'd)
8. Raise and support front of roof (2) to allow removal of windshield (1).
9. Pull windshield (1) forward. Remove grommet (3) from "A" beam (9) and disconnect leads 71 (4),
71B (5), and 57F (7) from body harness (6).
10. Remove windshield (1).
b. Disassembly
1. Remove eight capscrews (13), washers (12), two clevises (11) and shim(s) (10) if present, from
windshield (1)
2. Remove windshield wiper arm pivots (TM 9-2320-280-20).
3. Remove grommet (3) and jumper harness (8) from windshield (1).
4. Remove seals (17) and (18) from windshield (1).
NOTE
For instructions on replacement of rivets, refer to para. 22-7.
5. Remove twenty-seven rivets (16), retainer (15), and seal (14) from windshield (1).
c. Assembly
1.
Install seal (14) and retainer (15) on windshield (1) with twenty-seven rivets (16).
2.
Apply seals (17) and (18) to bottom of windshield (1).
3.
Install jumper harness (8) and grommet (3) in windshield (1).
4.
Install windshield wiper arm pivots (TM 9-2320-280-20), but do not install wiper arms.
5.
Install shim(s) (10), ifremoved, and two devises (11) on windshield (1) with eight washers (12) and
capscrews (13). Tighten capscrews (13) to 15 lb-ft (20 N-m).
14-16
