TM 9-2320-280-34
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Manual References
All models except M1026, M1026A1, M1036,
TM 9-2320-280-20
M1038, M1038A1, M1042, M1044,
TM 9-2320-280-24P
M1044A1, M1046, M1046A1 (serial
Equipment Condition
numbers 100,000 and above)
Winch removed (TM 9-2320-280-20).
Tools
General Safety Instructions
General mechanic's tool kit:
Lower control arm must be supported
automotive (Appendix G, Item 1)
during removal and installation.
Materials/Parts
Maintenance Level
Two locknuts (Appendix E, Item 65)
Direct support
WARNING
Lower control arm must be supported during removal and
installation. Failure to support lower control arm may cause
injury to personnel or damage to equipment.
a. Removal
1.
Remove locknut (1), washer (2), capscrew (3), and washer (2) from brace (4) and frame rail (10).
Discard locknut (1).
2.
Remove locknut (9), washer (6), capscrew (5), washer (6), and brace (4) from lower control arm (8)
and crossmember (7). Discard locknut (9).
b. Installation
1.
Install brace (4) on crossmember (7) and lower control arm (8) with washer (6), capscrew (5),
washer (6), and locknut (9).
2.
Install brace (4) on frame rail (10) with washer (2), capscrew (3), washer (2), and locknut (1).
Tighten locknut (9) to 260 lb-ft (353 Nm) and locknut (1) to 178 lb-ft (241 Nm).
3.
Change 2
