TM 9-2320-280-34
3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) (Cont'd)
NOTE
Early production 6.2 L engines were equipped with a left engine
heat shield. Removal is the same as right shield.
55.
Loosen three socket head screws (1) and right heat shield (3) from exhaust manifold (2).
Remove heat shield (3).
56.
Loosen nut (8) and washer (7) from front of starter (6) and bracket (9).
WARNING
Starter must be supported during removal. Failure to support
starter may cause injury to personnel or damage to equipment.
57.
Remove two capscrews (10), washers (11), starter (6), and shim(s) (5), if present, from engine (4).
NOTE
Perform step 58 for right engine mount on early production 6.2 L
engines only.
58.
Remove two capscrews (17), lockwashers (16), and starter support bracket (12) from right engine
mount and insulator assembly (13). Discard lockwashers (16).
59.
Remove three capscrews (15), lockwashers (14), and left and right engine mount and insulator
assembly (13) from engine (4). Discard lockwashers (14).
60.
Remove two nuts (19), lockwashers (18), and wiring harness bracket (20) from oil pan. Discard
lockwashers (18).
Change 2
