TM 9-2320-280-34
This task covers:
Installation
INITIAL SETUP:
Applicable Models
Material/Parts (cont'd)
All vehicles except: M997A2, M1025A2,
Four lockwashers (Appendix E, Item 117)
M1035A2, M1043A2, M1045A2,
Two lockwashers (Appendix E, Item 108)
M1097A2, M1123
Three lockwashers (Appendix E, Item 100)
Four lockwashers (Appendix E, Item 120)
Tools
Two spring tension washers
General mechanic's tool kit:
(Appendix E, Item 264)
automotive (Appendix G, Item 1)
Antiseize compound (Appendix B, Item 7)
Sealing compound (Appendix B, Item 50)
Special Tools
RTV sealant (Appendix B, Item 43)
Engine lifting sling (Appendix G, Item 22)
Engine/Transmission support sling
Torque adapter, 3/4 in.
(Appendix G, Item 107)
Belt tension gauge (Appendix G, Item 27)
Personnel Required
One mechanic
Materials/Parts
One assistant
Two cotter pins (Appendix E, Item 168)
Gasket (Appendix E, Item 36)
Manual References
Preformed packing (Appendix E, Item 179)
TM 9-2320-280-10
Three gaskets (Appendix E, Item 19)
TM 9-2320-280-20
Tiedown strap (Appendix E, Item 250)
TM 9-2320-280-24P
Locknut (Appendix E, Item 54)
Equipment Condition
Locknut (Appendix E, Item 73)
Two locknuts (Appendix E, Item 65)
Engine prepared for installation (para. 3-26).
Fourteen locknuts (Appendix E, Item 63)
General Safety Instructions
Four locknuts (Appendix E, Item 80)
Direct personnel to stand clear during
Four assembled locknuts
hoisting operation.
(Appendix E, Item 85)
Do not use hands to free engine if hangups
Lockwasher (Appendix E, Item 106)
or snags.
Two lockwashers (Appendix E, Item 114)
Transmission must be supported during
Two lockwashers (Appendix E, Item 95)
engine installation.
Two lockwashers (Appendix E, Item 109)
Two lockwashers (Appendix E, Item 110)
Maintenance Level
Two lockwashers (Appendix E, Item 103)
Direct support
Eight lockwashers (Appendix E, Item 104)
Four lockwashers (Appendix E, Item 107)
Installation
WARNING
Direct all personnel not participating in engine installation to
stand clear during hoisting operation. Failure to do this may cause
injury.
Do not use hands to free engine of hangups or snags. Use prybars
to avoid injury.
CAUTION
Always install engine slowly. Lower into chassis carefully and
closely observe all engine components to prevent engine damage.
If transmission support sling was installed, remove prior to engine
installation.
NOTE
All plugs must be removed from hoses and connections prior to
reconnection.
Assistant will be needed for steps 1 through 7.
This procedure is for 6.2L and detuned 6.5L engines only. Refer to
Change 2
