TM
11-7440-284-14
4-91. OUT OF VEHICLE CONFIGURATION. (CONT)
ACTION
REMARKS
ITEM
LOCATION
COMPONENT SETUP FOR FIELD OPERATION (CONT)
NOTE
Before removing electronic equipment table, remove tacfire
components and power cabling. See TM 11-7440-251-10,
TM 11-7440-253-10-1 for removal. Leave key generator rack,
message entry group rack, and electronic line printer rack
attached to electronic equipment table.
Remove, see paragraph 4-67.
Electronic equip-
8. Vehicle bed
Transfer from vehicle bed to
ment table (1)
operation site.
WARNING
Due to weight of table legs, care must be taken when lowering
into position.
NOTE
To lower electronic equipment table legs, see steps 9 through 12.
Remove.
9. Field operation
Quick release
pin (2)
site
Table leg (3)
Lower.
10.
When lowered, table leg hole and
hole in support bracket must be alined.
Install.
11.
Quick release pin
(2) and table leg
hole (4)
Using quick release pin, adjust leg to
Quick release pin
12.
desired height.
(5) and table
leg (3)
There are four table legs. Steps 9
through 12 are typical for all four table
legs.
Table legs (6)
Do steps 9 through 12 again.
13.
Adjust all legs to same height.
4-180
