TM 11-7440-284-14
4-27. INSTALLING ELECTRONIC EQUIPMENT TABLE.
This task covers:
Installation
INITIAL SETUP
Personnel Required
Tools
Two mechanics
1/2-inch box end wrench
(2 required)
Equipment Condition
Materials/Parts
Holes drilled for front
reinforcement support.
Electronic equipment table
5/16-24 x 2 1/4 inch long hex
head screw (8 required)
5/16-inch flat washer
(16 required)
5/16-24 elastic stop nut
(8 required)
ACTION
REMARKS
ITEM
LOCATION
Place table on top of radio mount and aline
Table (1) and
1. Top of radio
holes.
radio mount (2)
mount
Install, handtighten.
Screw (3),
2.
There are eight screws. Step 2
flat washer (4),
is typical for all eight screws.
flat washer (5)
and nut (6)
Do step 2 again.
Screw holes (7)
3.
Using two 1/2-inch box wrenches, tighten.
Screws (3)
4.
4-54
