TM 11-7440-284-14
4-28. INSTALLING FRONT REINFORCEMENT SUPPORT.
This task covers:
Installation
INITIAL SETUP
Materials/Parts (Cont)
Tools
5/16-18 x 1 1/2 inch long hex
7/16-inch box wrench
head screw (4 required)
(2 required)
5/16-18 elastic stop nut
1/2-inch box wrench
(4 required)
(2 required)
5/16-inch flat washer
(8 required)
Materials/Parts
Personnel Required
Front reinforcement support
1/4-20 x 3 inch long hex head
One mechanic
screw (6 required)
1/4-20 eleastic stop nut
(6 required)
Equipment Condition
1/4-inch flat washer
Holes predrilled and electronic
(12 required)
1/4-inch split Iockwasher
equipment table installed.
ACTION
REMARKS
ITEM
LOCATION
Install and aline holes.
Support (1) and
1. Between electronic
forward wall (2)
equipment table and
forward wall
NOTE
All screws must face center of support
Install,
handtighten.
Screw (3),
2.
flat washer (4),
There are six screws. Step 2 is
flat washer (5),
typical for all six screws.
Iockwasher (6)
and nut (7)
Do step 2 again.
3.
Screw hole (8)
Using two 7/16-inch box wrenches, tighten.
Screws (3)
4.
4-56
