TM 11-7440-284-14
4-21. REMOVING CARGO TIE-DOWN ASSEMBLIES.
This task covers:
Removal
INITIAL SETUP
Personnel Required
Tools
Two mechanics
1/2-inch box wrench
(2 required)
Equipment Condition
Stiff wire brush
Truck set at installation site.
Materials/Parts
None
ACTION
REMARKS
ITEM
LOCATION
NOTE
A helper will be needed outside carrier. Clean back of cargo
tie-down assemblies.
1. Carrier inner
Using two 1/2-inch box wrenches, remove.
Screw (1), flat
There are four screws. Step 1 is
walls
washer (2) and
typical for all four screws.
nut (3)
Do step 1 again.
2.
Screws (4)
Remove,
Cargo tie-down
3.
There are eight cargo tie-down
assembly (5)
assemblies. Steps 1, 2 and 3 are
typical for all eight cargo tie-
down assemblies.
Do steps 1, 2 and 3 again.
4.
Cargo tie-down
Store cargo tie-down assemblies and
assemblies (6)
hardware for future use.
4-38
