TM 11-7440-284-14
4-20. INSTALLING REAR ANTENNA MOUNTING BRACKET.
This task covers:
Installation
INITIAL SETUP
Materials/Parts (Cont)
Tools
Rear antenna bracket
3/8-inch drive, 6 inch
Rear reflector
long extension bar
1/4-20 x 5/8 inch long
3/8-inch drive socket wrench
panhead screw (2 required)
9/16-inch socket
14-inch split Iockwasher
9/16-inch box wrench
(2 required)
(2 required)
Cross-tip screwdriver
Personnel Required
Materials/Parts
Two mechanics
3/8-24 x 1 inch long
Equipment Condition
hex head screw (6 required)
3/8-inch flat washer
Antenna bracket mounting holes
(12 required)
drilled and rear reflector
3/8-24 self-locking nut
removed.
(6 required)
ACTION
REMARKS
ITEM
LOCATION
NOTE
A helper will be needed outside carrier.
Using cross-tip screwdriver, remove.
Screw (1) and
1. Inside corner
There are four screws. Step 1 is
plate (2)
above rear curb-
typical for all four screws.
side seat
Do step 1 again.
2.
Screws (3)
Plate (2)
Remove.
3.
Place and aline holes.
Bracket (4) and
4. Outside carrier,
carrier wall (5)
rear curbside
wall
4-34
