TM 17-7440-284-14
4-22. INSTALLING ADAPTER ASSEMBLIES.
This task covers:
Installation
INITIAL SETUP
Materials/Parts (Cont)
Tools
Adapter assemblies (8 required)
1/2-inch box wrench
Sealant compound
(2 required)
Personnel Required
Materials/Parts
Two mechanics
5/16-18 x 1 1/2 inch long hex
head screw (16 required)
Equipment Condition
5/16-inch flat washer
(32 required)
Cargo tie-down assemblies
5/16-18 self-locking nut
removed.
(16 required)
ACTION
ITEM
REMARKS
LOCATION
NOTE
A helper will be needed outside carrier. Grind or chisel any
weld slag from tie-down sockets. Put sealant on back of
adapters and mounting hardware before installing.
Place and aline holes.
1. Carrier inner
Adapter (1) and
Arrows on adapter must be facing
tie-down
walls
up. Put sealant on adapters.
socket (2)
Using two 1/2-inch box wrenches, install.
2.
Screw (3), flat
There are two screws. Step 1 is
washer (4), flat
typical for each screw.
washer (5) and
nut (6)
Do step 2 again.
Hole (7)
3.
There are eight adapters. Steps 1,
2 and 3 are typical for all eight
adapters.
Remaining seven
4.
Do steps 1, 2 and 3 again, for remaining
adapters (8)
seven chapters.
4-40
