TM 9-2320-289-34
3-7. CYLINDER HEAD REMOVAL (Con’t).
NOTE
l Rear bolt (6) in left cylinder head (5) may have to remain in cylinder
head during removal.
• An assistant will be required for step 2.
2.
Remove 17 bolts (6), starting with outside bolts and working toward center. Remove cylinder
head (5) and cylinder head gasket (4) from engine block (3). Discard cylinder head gasket,
b.
CLEANING AND INSPECTION
CAUTION
DO NOT use a motorized wire brush to clean cylinder head (5). Failure to
follow this caution may result In damage to cylinder head.
1.
Inspect dowel pins (7) for damage. Remove if damaged.
2.
Clean carbon deposits, sealing compound, and all gasket material from cylinder head (5) and
engine block (3). Remove all sealant and dirt from threads in engine block.
3.
Clean sealing compound from bolt (6) threads.
TA50633
3 - 21
