TM 9-2320-289-34
3-7. CYLINDER HEAD REMOVAL.
This task covers:
a. Removal
b. Cleaning and Inspection
INITIAL SETUP:
Equipment Condition
Materlals/Parts
Rocker arm cover, rocker arm assemblies,
and pushrods on applicable cylinder head
removed, (See paragraph 3-6)
Oil level indicator tube removed (if removing
left cylinder head). (See TM 9-2320-289-20)
Air conditioner compressor brackets
removed (if removing left cylinder head
from Ml 01 O). (See paragraph 10-24)
Left side alternator bracket removed
(if removing left cylinder head).
(See TM 9-2320-289-20)
Right side alternator or Ml 010 alternator
bracket removed (if removing right cylinder
head), (See TM 9-2320-289-20)
Exhaust manifold removed.
(See TM 9-2320-289-20)
Radiator, bypass, and heater hoses
disconnected (if being performed in truck).
(See TM 9-2320-289-20)
Thermostat and crossover pipe removed.
(See TM 9-2320-289-20) “ ‘
l Fuel injector nozzle gaskets
(as needed)
Tools/Test Equipment
• Socket wrench adapter, J-29873
Personnel Required
l MOS 63W (2)
Manual References
l TM 9-2320-289-20
a . R E M O V A L
NOTE
l If engine is out of truck,
perform step 2.
l Ensure that leads are tagged for
installation.
1.
Tag and disconnect glow plug leads
from glow plugs on cylinder head (5)
to be removed. If removing left
cylinder head, disconnect glow plug
wiring harness (2) from temperature
sensor
(1),
Remove
nut,
and
disconnect leads, ground strap, and
Iockwasher from engine stud. Discard
Iockwasher.
TA50632
3-20
