TM 9-2320-289-34
10-11. CARGO BODY PICKUP BOX MAINTENANCE.
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
b. 1. Preparation of Side Panel
(M1028A2 and M1028A3)
INITIAL SETUP:
Equipment Condition (See NOTE below)
l
l
l
l
l
l
l
l
l
l
Troop seats removed if installed.
(See TM 9-2320 -289-1 O)
Endgate removed. (See TM 9-2320-289-20)
S-250 communications shelter removed
(M1028, M1028A1, M1028A2, and
M1028A3 only)
Communications rack and junction box
removed (M1008A1 only).
(See TM 9-2320-289-20)
Shelter tie-downs removed (Ml 028,
M1028A1, M1028A2, and M1028A3 only).
(See TM 9-2320-289-20)
Taillights removed. (See TM 9-2320-289-20)
Fuel tank filler door removed,
(See TM 9-2320-289-20)
Cargo body cover and frame removed if
installed, (See TM 9-2320-289-20)
Winterization kit components removed as
required, (See TM 9-2320-289-20)
Rear fender side marker lights disconnected
(M1028A2 and M1028A3),
(See TM 9-2320-289-20)
General Safety Instructions
Materials/Parts
Two starwashers
Primer (Item 52, Appendix B)
Sealing compound
(Item 60, Appendix B)
Tape (Item 68, Appendix B)
Tools/Test Equipment
l Torque wrench
l Power hacksaw
• Holesaw
• Cutter head air chisel
Personnel Required
l MOS 44B10 (2)
Manual References
l TM 9-237
l TM 9-2320-289-20
l TM 9-2320-289-34P
• Use caution when handling sheet metal.
• Wear protective clothing when cutting sheet metal.
NOTE
Only perform Equipment Conditions required to gain access to damaged
component,
a. REMOVAL
NOTE
If only side panels (1 1), wheel house panel (19), or rear fender on M1028A2
or 1028A3 need replacing, pickup box does not need to be removed from
truck.
1 .
Remove screw (1) and starwasher (3) and disconnect rear lamp wiring harness ground (2) from
pickup box. Discard starwasher.
2 .
Disconnect rear lamp wiring harness (4) from rear lamp wiring harness (5). Remove rear lamp
wiring harness (4).
10-36
Change 2
