TM 9-2320-289-34
8-4.
POWER STEERING GEAR REPAIR (Con’t).
15.
16.
17.
With stamped identification
Plug (17). Install new “O”
end up, press needle bearing (25) 5/8 in. (15.88 mm) into adjuster
ring (24) on adjuster plug.
Install new stub shaft seal (26), new stub shaft dust seal (27), and retaining ring (28) on
adjuster plug (17).
NOTE
Ensure that bearing retainer (19) raised areas do not extend above bearing
spacer (20) when bearing retainer is seated, Bearing spacer must be free
to rotate.
Install large upper bearing race (23), upper thrust bearing (22), small upper bearing race (21),
thrust bearing spacer (20), and bearing retainer (19) on adjuster plug (17).
TA50494
8-25
