8-4. POWER STEERING GEAR REPAIR (Cont)

8-4. POWER STEERING GEAR REPAIR (Cont) - TM-9-2320-289-34_759

8-4. POWER STEERING GEAR REPAIR (Cont) - TM-9-2320-289-34_761

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
743

TM 9-2320-289-34 8-4. POWER STEERING GEAR REPAIR (Con’t). 8. 9 . 10. 11. NOTE In order to assist in assembly, ensure that teflon valve body rings (35) are soaked in warm water before assembly. Lubricate 3 new teflon valve body rings (35) and 3 new “O” rings with hydraulic fluid and install onto valve assembly (34). Install new “ O“ ring on spool valve (36). Lubricate spool valve and valve assembly (34) with hydraulic fluid. Install spool valve approximately 1/4 in. (6.35 mm) into valve bore. Install stub shaft (8) into spool valve (36) so that pin on stub shaft engages upper hole in spool valve. Insert stub shaft (8) and spool valve (36) into valve assembly (34) so that slot (37) on shaft cap locks with pin inside valve assembly and cap seats against shoulder. 12. 13. Install new “O“ ring (33) into end of valve assembly (34). Assemble race (31 ), thrust bearing (30), and race (29) on worm gear (32) with bevel on races facing away from drive end of worm gear. 14. Engage pin in worm worm gear as a unit gear (32) with slot into housing (7). in valve assembly (34). Install valve assembly and TA50493 8-24

Privacy Statement
Press Release
Contact