6-12. STEERING KNUCKLE, ARM, AND BALL JOINT MAINTENANCE (M1009)

6-12. STEERING KNUCKLE, ARM, AND BALL JOINT MAINTENANCE (M1009) (Cont) - TM-9-2320-289-34_631

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
613

TM 9-2320-289-34 6-12. STEERING KNUCKLE, ARM, AND BALL JOINT MAINTENANCE (M1009). This task covers: a. Disassembly b. Assembly INITIAL SETUP: Equipment Condition l Steering tie-rod removed. (See TM 9-2320-289-20) • Connecting rod disconnected from steering arm (left side only), (See TM 9-2320-289-20) l Front axle shaft removed. (See paragraph 6-4) Tools/Test Equipment l Ball joint adapter set, J-23454-D l Ball stud adjuster sleeve, J-23447 l Lower ball joint remover, J-33122 • “C“ clamp l Snapring pliers l Torque wrench Materials/Parts l One flat washer • One steering knuckle socket repair kit l One cotter pin l Three locknuts a. DISASSEMBLY l l l l NOTE Left side steering knuckle (5), arm (l), and ball joint (12) disassembly is given. Right side steering knuckle (5) has no steering arm (1). It may be necessary to apply heat to loosen steering arm (1). If removing steering arm (1), perform step 1, 1. Remove 3 locknuts (3) at steering arm (1), Remove 3 stud adapters (4). Remove steering arm from steering knuckle (5) . Discard locknuts. TA50569 6-78

Privacy Statement
Press Release
Contact