STEERING KNUCKLE AND ARM MAINTENANCE (ALL EXCEPT M1009)
Remove seal (14) and bearing (13). Inspect bearing for damage and binding, Replace if
damaged or binding. Discard seal. If damaged, remove bearing cup (12) and retainer (11).
Inspect all grease fittings and replace if damaged.
l On left side, steering arm is installed to steering knuckle (8) with 4
nuts. On right side, upper kingpin bearing cap is installed to steering
knuckle with 4 bolts and Iockwashers.
l Left side assembly is given,
Seal (14) will protrude slightly from surface of axle housing (9) flange
If removed, assemble retainer (11) and bearing cup (12), and install to axle housing (9)
flange. Fill area in retainer with grease. Grease bearing (13) and install, Install new seal (14).