TM 9-2320-289-34
5-15.
TRANSMISSION OIL PUMP MAINTENANCE (Con’t).
NOTE
If turbine shaft (5) cannot be rotated as oil pump assembly (3) is being
pulled into place, forward or direct clutch housings have not been
installed properly to index with all clutch plates. This condition must be
corrected before oil pump assembly is fully seated. (See paragraph 5-16
or 5-17)
6. Loosely install 6 new rubber-coated
washers and bolts (1), Tighten all
bolts progressively to 20 lb. -ft.
(27 N.m).
7. Apply a thin coat of RTV sealant to
outside of oil pump seal (2) body.
Install new oil pump seal.
FOLLOW-ON TASKS:
l Check front unit end play. (See paragraph 5-14)
TA50262
5-81
