TM 9-2320-289-34
4-2.
ALTERNATOR TESTING AND REPAIR (ALL EXCEPT M1010) (Con’t).
4.
Remove nut (16), “ R“ terminal bar (19), fiber insulator (30), plastic insulator (29) and “R“
terminal stud (28). Discard all components.
5.
Remove 3 insulated screws (11), resistor (13), diode trio (20), brush holder assembly (9), and
voltage regulator (12).
6.
Remove screw (21 ) and disconnect capacitor lead (23) from rectifier bridge (7). Remove
screw (24), wire retainer, and capacitor (8).
7,
Remove screw (22) and rectifier bridge-to-regulator jumper wire (10).
8.
Remove nut (17), nut (14), bus bar (15), and fiber insulator (25). Remove battery positive (+)
terminal (26) and plastic insulator (27) from outside of end frame (1). Discard all components.
9.
On outside of end frame (1), remove nut, Iockwasher, flat washer, and fiber insulator from
negative (-) terminal stud (18). Discard all components.
TA50777
4-4
