TM 9-2320-289-34
3-45.
FUEL INJECTOR PUMP CALIBRATION (Con’t).
4,
Set rpm at 600, with throttle lever (17) in low idle position. Housing pressure gage (7) reading
should be 8–12 psi (55–83 kPa).
5 .
Set adjustable dc voltage source (16) to 9.0 volts. Connect positive test lead (14) to cold
advance solenoid terminal. Housing pressure gage (7) reading should be 0-1 psi (0-6.9 kPa).
Disconnect positive test lead.
6 .
Set rpm at 600, with throttle lever (17) in low idle position. Flowmeter reading must be
12.5-16.5 cc. If flowmeter reading is not correct, perform step 7.
TA50758
3-165
