3-29. ENGINE AND ENGINE MOUNT INSTALLATION

3-29. ENGINE AND ENGINE MOUNT INSTALLATION (Cont) - TM-9-2320-289-34_168

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
150

TM 9-2320-289-34 3-29. ENGINE AND ENGINE MOUNT INSTALLATION. This task covers: a. Installation INITIAL SETUP: Equipment Condition Materials/Parts l Engine or engine mounts removed. l Eight locknuts (See paragraph 3-3) Tools/Test Equipment PersonneL Required l Torque wrench l MOS 63W (2) General Safety Instructions l DO NOT place hands between engine and transmission when installing engine. a. INSTALLATION WARNING DO NOT place hands between engine (4) and transmission when installing engine. Failure to follow this caution may result In injury to personnel. CAUTION Ensure that wiring, pipes, and hoses are clear of engine (4) during Installation. Failure to follow this caution may result In damage to wiring, pipes, and hoses. NOTE l An assistant will guide engine (4) into engine compartment as it is being lowered. Guide exhaust manifold studs over exhaust pipes. l If only installing engine mount (6) or engine mount brackets (2), perform steps 4 and 5. 1. Install suitable lifting device on engine lift brackets at left front and right rear of engine (4). Install engine in engine compartment. T A 5 0 6 97 3 - 92

Privacy Statement
Press Release
Contact