TM 9-2320-289-34
3-29. ENGINE AND ENGINE MOUNT INSTALLATION (Con’t).
4.
Install new engine mount (6) with 3
washers, bolts, and new locknuts if
removed.
Install spacer (3) and
engine mount bracket (2) with 3
washers (8) and bolts (7) if removed,
Tighten engine mount locknuts to
30 Ib.-ft. (41 N.m). Tighten engine
mount bracket bolts to 35 Ib.-ft.
(47 N.m). Lower side of engine (4)
and remove jack. Repeat for other
side.
5. Install screw (1) through left side
engine mount bracket (2) and engine
mount (6). Install new locknut (5).
Tighten
l o c k n u t t o
55 Ib.-ft.
(75 Nom). Repeat this step for right
side. Remove engine lifting device.
CAUTION
Ensure that torque converter (13)
is flush against flywheel (12) and
able to rotate freely by hand.
Failure to follow this caution will
result in damage to engine (4) and
transmission.
6.
Ailne marks made during removal on flywheel (12) and torque converter (13). Rotate flywheel
and install 6 bolts (11) to fiywheel and torque converter finger tight only. Once all bolts are
installed, tighten to 50 ib.-ft. (68 N.m).
3 - 94
T A 5 0 6 9 9
