3-22. TORSIONAL DAMPER AND CRANKCASE COVER INSTALLATION (Cont)

3-22. TORSIONAL DAMPER AND CRANKCASE COVER INSTALLATION

3-22. TORSIONAL DAMPER AND CRANKCASE COVER INSTALLATION (Cont) - TM-9-2320-289-34_146

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
128

TM 9-2320-289-34 3-22. TORSIONAL DAMPER AND CRANKCASE COVER INSTALLATION (Con’t). 2. Apply a 0.09 in. (2 mm) bead of anaerobic sealing compound (11 ) to crankcase cover (4) in pattern shown. Apply a 0.18 in. (5 mm) bead of RTV sealant to lower surface of crankcase cover where it mates with engine oil pan. 3. Install new fuel injector pump gasket (12) on studs at rear of crankcase cover (4). Install crankcase cover on engine block (5) with 4 bolts (8). Install bolt (6). Tighten bolts to 35 Ib.-ft. (47 N.m). TA50677 3 - 7 0

Privacy Statement
Press Release
Contact